HOW TO USE THE AIR PROGRAM CARD:
Connect the ESC to the motor.
Set the blue jumpers on the programming card for the settings you want
(see ESC instructions for details on individual options).
Connect the Signal Wire to the programming card connector marked “ - + P”.
Connect the ESC to the battery pack. For the ESC without a built-in BEC
(OPTO) you need to connect the extra power (4.8-6.0V) or UBEC to the
connector marked “ - +”.
You should hear one short beep to confirm that your settings are valid
and have been stored. If you hear a long beep (about 10 seconds) the
settings are invalid and have not been stored. Check you settings and
Disconnect your battery pack and the programming card. Your ESC is now programmed and ready to run.
1. Size: 55.0mm*42.5mm*3.5mm(L*W*H)
2. Weight: 6.5g