This programming card can be used to program all Mantis Series brushless ESCs quickly and easily.
Note: ONLY compatible with std Mantis-Series ESCs. Cannot be used to program Mantis Slim ESCs.
Specification:
Dimensions: 70x45x13mm(LxWxH)
Weight: 23g
Programmable Options:
Brake setting (off/soft/mid/hard -- default: off)
Battery type: (Ni-XX/LiPo/LiFe -- default: LiPo auto detect)
Low voltage cutoff setting (2.8V / 3.0V / 3.2V / None -- default: 3.0V)
Factory default setup reset Timing settings (auto / 2° / 5° / 8° /15° / 22° /30° -- default: auto)
SBEC output voltage (on 45A and larger models only) (5.0V / 5.5V / 6.0V -- default: 5.0V)
Governor mode (RPM off / 1st soft start / 2nd soft start / gov mod 1 / gov mod 2 -- default: RPM off)
Motor rotation (forward / reverse -- default: forward)
Start-up strength (10% / 15% / 20% / 25% / 30% / 35% / 40% / 45% / 50% -- default: 30%)
Low voltage cutoff type: (reduce power / cut-off power -- default: reduce)
How to Use the LED Program Card:
1.ZTW Program card with LED display is easy to use and convenient to
carry. All of the programmable functions are shown on the program card.
2.Turn on the ESC. Remove the signal wire and plug it into the
top-socket on the program card, wait for 2 seconds until the LED is on.
3.If ESC is not connected with the batteries, the program card should
be connected with other power supply, the range of power supply is from
5.0V to 6.3V.
4.Press the button ”Menu” on the program card and circularly select
each programmable function. At that time the number of programmable
function will be displayed on the left of the LED, the current value
will be displayed on the right side. Then press the button “Value” to
change the value and press the button “OK” to confirm. At the same time
the Red indicating LEDs of both program card and the ESC will blink.
Turn off the ESC, the modified settings will be saved in the ESC`s
memory.
5.Press the button “Reset” to restore the default settings.
