Shopping Bag
YGE 120 HVT - NP with prop positioning
YGE 120 HVT - NP with prop positioning

YGE 120 HVT - NP with prop positioning

Your Price: U$399.00
In Stock
Part Number:YGE 120 HVT
The new YGE120HVT can now also be used for positioning propellers that are built into the nose of the fuselage. The position is detected via a sensor that is plugged directly into the speed controller. This makes it possible to determine the position of the spinner or the propeller. This gives you the opportunity to choose a well-fitting propeller that fits well in the lateral position. This not only brings an optical advantage, primarily it brings less drag from an aerodynamic point of view.
The advantages of positioning are:
-When landing, the propeller is protected
-Better fit, less resistance
-Good optics. Can be integrated into the design
- Scale
-Advanced Technology

Details and technical data
  • Controller with optocoupler, no
  • BEC In addition to the telemetry output, versatile connection strips enable extended interfaces for industrial and special applications such as CAN, potentiometer control.
  • “T” stands for telemetry. The following telemetry protocols are currently compatible: Mikado VBC, Graupner HoTT V4, Jeti ExBUS, Multiplex Sensor BUS V2, own YGE protocol for further telemetry connections via e.g. YGE TexY (Futaba, Spektrum, FrSky, Core), MSH Brain 2, Spirit FBL
  • Updateable (optional USB adapter available)
  • completely revised hardware and software (32-bit)
  • the PWM frequency is automatically adjusted to the needs of the motor
  • The specified flow is the maximum continuous full throttle flow with good cooling.
  • Max. 120 A continuous with adequate cooling, 5 Sec. 150 A.
  • 4 bis 14s LiPo, throttle reduction at low voltage.
  • 5 bis 15s LiFePO4, throttle reduction at low voltage.
  • Disable low voltage cutoff
  • Opto-coupling.
  • rpm regulation (Governor-Mode).
  • Soft start set individually.
  • Active freewheel.
  • Automatic Timing, or adjustable in 6 steps.
  • Adjustable F3A Brake.
  • Normal brake adjustable in 3 Steps.
  • Switching frequency: 8 to 16 kHz.
  • Max rpm: 240.000 rpm (2-Pole).
  • Overheat- / Overload warning.
  • Anti-Spark.
  • Dimension: 69 x 62 x 33 mm
  • Weight: 148 g without - and 184 g with cable 6/4 mm²
  • Basic programming via mode setup.
  • Fine adjustment and selection of the telemetry protocol via PC setup, suitable USB adapter is available as an option.
  • The positioning should be tested to see if the actuator can cope with the motor. Caution: No update may be carried out on the positioning controllers.
  •  Installation instructions can be found in the download.
  • Further details on technical data and programming can be found on the manufacturer's website (www.yge.de)

Accessories

YGE ProgCard III
Sale
U$29.00  U$22.00
Out of Stock
 
 

Related Items